Indicators flashing too fast?
Vehicles warning system showing the bulb is blown?
If you have fitted LED stop/tail lights or indicator bulbs (like 1156, 1157, 3156, 3157, 7440, 7443) to your car or bike you may find that either the indicators flash too fast or the vehicles warning systems shows the bulbs as being blown, this is because LED bulbs have a lot less resistance than standard glass filament bulbs.
Using splice taps or splicing method, connect one wire to ground and the other wire to the turn/brake wire. You do not have to cut your car's wiring. Squeeze splice taps with pliers. One Load Resistor required for each turn signal bulb. Instructions are here
2 pre-wired Resistors (Use electrical tape or splice taps (not included))