LED Car Lights

RGB Controller Radio Frequency Control for LED Strips
RGB Controller Radio Frequency Control for LED Strips
  • Model: RF-RGB-CNTL
  • Manufactured by: Genssi

$19.99

Add to Cart:         
Details:
  • This is the ultimate RGB controller you can buy. Uses wireless RF technology that goes through walls up to 50 Feet, maximum 100ft in most uses. RF is better than IR. IR controllers you must point directly at the sensor. RF is like a garage opener remote. This controller also has a music function. It will beat to bass with the built in microphone or with line input.
  • 144W at 12V, 12A Output 12V Input from Battery, Vehicle or AC-DC Adapter (not included)
  • L 128mm x W65mm x H25mm 8 Key RF Remote Controller with multi functions including color change, brightness, speed change, pattern change. CE and ROHS 433MHz Static Power usage less than 1W Includes: Control Box (Silver), Remote Control (Silver), Battery, Input plug for music input
  • To make us of this product you will need an AC-DC Adapter or Car Battery. Works with voltages 10V-14V. Offers two voltage inputes, A. by round adapter plug or B. By bare wire to 2 terminals V+/-
  • Works with RGB Strips (4 wire) or any custom setup strip you choose. No instructions provided.

 

RF = Radio Freq - Can go through walls - No Pointing needed!

Built In Mic for lights changing with music!

12V Input from Battery required, Vehicle or AC-DC Adapter (not included)

L 128mm x W 65mm x H 25mm

8 Key RF Remote Controller with multi functions including color change, brightness, speed change, pattern change.

CE and ROHS

433MHz

Common Anode Wiring (Your LED Strip Must be Common Anode type with V+ mark)

Static Power usage less than 1W

Max Power: 144W (4 Amps/channel (12 Amps total)

Includes: Control Box (Silver), Remote Control (Silver), Battery, Input plug for music input

Battery Type Mode: 23A, 12V for Remote (Included)

Notes: Red LED will come on when unit is receiving power, Green LED will flash when RF signal is received from handheld transmitter

Up and DOWN buttons will only work when unit is in one of the four color-changing (dynamic) modes.

30M Max of LED strip can be used. Any longer you will need a transmission amplifier.

Do not exceed 80% of the power supply capacity when calculating the power supply to use. Example 150W power supply should not be loaded more than 120W.

 

 

 

Add to Cart:         

Customers who bought this product also purchased...